Danfoss VLT AQUA Operating Instructions Manual page 93

VLT AQUA Low Harmonic Drive Operating In-
structions
0-39 Display Text 3
Range:
0 N/A* [0 - 0 N/A]
0-70 Set Date and Time
Range:
2000-01-01 [2000-01-01 00:00]
00:00 –
2099-12-01
23:59 *
0-71 Date Format
Option:
[0] * YYYY-MM-DD
[1] DD-MM-YYYY
[2] MM/DD/YYYY
0-72 Time Format
Option:
[0] * 24 h
[1] 12 h
0-74 DST/Summertime
Option:
[0] * Off
[2] Manual
0-76 DST/Summertime Start
Range:
Application [Application dependant]
dependent*
0-77 DST/Summertime End
Range:
Application [Application dependant]
dependent*
6.3.3 General Settings, 1-0*
Define whether the frequency converter operates in open loop or closed loop.
Function:
In this parameter it is possible to write an individual text string for display in the LCP or to be read
via serial communication. If to be displayed permanently select Display Text 3 in par. 0-20
Line 1.1 Small ,par. 0-21 Display Line 1.2 Small , par. 0-22 Display Line 1.3 Small , par. 0-23 Display
Line 2 Large or par. 0-24 Display Line 3 Large . Use the
◀ ▶
character. Use the and buttons to move the cursor. When a character is highlighted by the
cursor, this character can be changed. A character can be inserted by placing the cursor between
▲ ▼
two characters and pressing or
Function:
Sets the date and time of the internal clock. The format to be used is set in par. 0-71 and 0-72.
NB!
This parameter does not display the actual time. This can be read in par. 0-89.
The clock will not begin counting until a setting different from default has been
made.
Function:
Sets the date format to be used in the LCP.
Sets the date format to be used in the LCP.
Sets the date format to be used in the LCP.
Function:
Sets the time format to be used in the LCP.
Function:
Choose how Daylight Saving Time/Summertime should be handled. For manual DST/Summertime
enter the start date and end date in par. 0-76
time End .
Function:
Sets the date and time when summertime/DST starts. The date is programmed in the format se-
Date Format .
lected in par. 0-71
Function:
Sets the date and time when summertime/DST ends. The date is programmed in the format selected
Date Format .
in par. 0-71
®
MG.20.T1.02 - VLT is a registered Danfoss trademark
6 How to Programme the Low Harmonic Drive
▲ ▼
or buttons on the LCP to change a
.
DST/Summertime Start and par. 0-77 DST/Summer-
Display
6
93