Table of Contents
Advertisement
2 Names of parts and their Functions
2-1 Front Controller Parts
POWER switch
This switch is used to turn ON/OFF the monitor.
* This switch will not turn ON/OFF the AC power
supply for the monitor.
* It takes several seconds for an image to come up
after power-on.
POWER LED
This LED is lit up in green when the power supply
for the monitor is ON.
* When running on battery,
starts flickering to tell you the remaining battery
power becomes low. In such case, immediately
turn off the power and replace the battery with
new one. When the remaining battery power gets
to the lower limit, the power is forced to shut off
and the LED indicator starts flickering at 0.5 sec.
intervals after alarm is issued for 30 sec. (the
LED flickering is quicken for about 30 sec.)
* When using a battery, set the nominal voltage on
the menu appropriately in accordance with the
battery to be used. For the setting item, refer to
4-4. Description of MENU 2 Functions
MENU/ENT switch
This switch is pressed to display the menu screen
and to change the menu screen.
This switch is also pressed to confirm entries on
the menu.
PRESET switch
This switch is pressed to display the preset menu.
* This switch is ineffective when the menu is dis-
played.
ESC switch
This switch is pressed to escape from menu op-
eration.
this LED indicator
.
- 4 -
VBS switch/
(LEFT) switch
To select the VBS input, this switch is pressed
with the menu and preset menu not displayed.
When the menu or preset menu is displayed, this
switch is used to select setting items on each
menu.
(RIGHT) switch
SDI (TST)switch/
To select the SDI input, this switch is pressed with
the menu and preset menu not displayed.
To display the incorporated test signal, this
switch is pressed and held for several seconds
with the menu and preset menu not displayed.
When the menu or preset menu is displayed, this
switch is used to select setting items on each
menu.
CH SELECT switch/
switch
To select channels when the SDI input is selected,
this switch is pressed with the menu and preset
menu not displayed.
When the menu or preset menu is displayed, this
switch is used to change the setting of each item.
When the internal test signal is displayed, this
switch is used to change the type of test signal.
The following three types of test signals are in-
corporated.
<100% Window>
-2%
+2%
0-100%
0% 100%
Staircase
0%
wave
<Staircase wave with pluge>
21
22
(UP)/
(DOWN)
100%
<Color Bar>
Advertisement
Table of Contents
