Double Shift N-Bits Left: Nsll(058) - Omron SYSMAC CV Series Operation Manual

Shift Instructions
Precautions
Flags
Example

5-14-9 DOUBLE SHIFT N-BITS LEFT: NSLL(058)

Ladder Symbol
( )
058
NSLL D C
Variations
NSLL(058)
Description
170
After the bits have been shifted, the status of the bits from which data was shifted
(i.e., the number of bits shifted, beginning with the leftmost bit of the specified
word) will be set to "0" or to the status of the MSB, depending on the control word
setting.
Control Word Contents
MSB LSB
0
Number of bits to shift (00 to 16)
Status of remaining bits
0: 0
8: Status of MSB
Refer to page 115 for general precautions on operand data areas.
ER (A50003): Number of bits to shift is out of range.
Content of a*DM word is not BCD when set for BCD.
CY (A50004): "1" has been shifted to CY.
EQ (A50006) Content of word D after the shift is all zeros.
N (A50008) Same status as leftmost bit (MSB) of word D after shift.
See the example provided in 5-14-10 DOUBLE SHIFT N-BITS RIGHT:
NSRL(059) .
Operand Data Areas
D: Beginning shift word CIO, G, A, DM
C: Control word
When the execution condition is OFF, NSLL(058) is not executed. When the ex-
ecution condition is ON, NSLL(058) shifts the status of the 32 bits in the specified
words to the left the specified number of bits.
The number of bits to shift is set in the two rightmost digits of the control word. If
the number is "0," the word data will not be shifted. The appropriate flags will turn
ON and OFF, however, according to data in the specified word.
A5004
CY
. . . .
. . . .
Wd D+1
CIO, G, A, T, C, #, DM
Number of bits shifted
Wd D
Section 5-14
(CVM1 V2)