Post-Repair Procedures - Keysight Technologies FieldFox N9913A Service Manual

Repair and Replacement Procedures

Post-Repair Procedures

Post-Repair Procedures
After the replacement of an assembly, you must perform the service
procedures in the order listed in
Procedures referenced in this table are located in
Adjustments,"
Table 7-2 Related Service Procedures
Replaced Assembly
Main battery
RPG
PORT 1 connector or
associated cable (W1)
replaced or disturbed.
PORT 2 connector or
associated cable (W2)
replaced or disturbed.
Front case (including A1
keypad)
A2 LCD
A3 front panel interface
board
A4 RF board
A5 System board
A6 SOM board
A7 RTC Battery
* Refer to the following manual checks and procedures for details.
Keysight FieldFox Handheld Analyzers Service Guide
unless specified otherwise.
Ad justments, etc.
None needed.
None needed.
Error Terms adjustment if applicable.
Error Terms adjustment if applicable.
None needed.
None needed.
None needed.
All TME based adjustments that apply to the
installed option configuration.
First, load the instrument serial number into the
A5 System board.*
All TME based adjustments that apply to the
installed option configuration.
Install firmware from SD card.*
Re-install options.*
All TME based adjustments that apply to the
installed option configuration.
None needed.
Table 7-2.
Chapter 3, "Tests and
TME Tests or Other Procedures
None needed.
Manual check of RPG operation.*
Error Terms test if applicable.
Error Terms test if applicable.
Absolute Amplitude Accuracy Test.
Total Abs Amp Accy LF Test.
Total Abs Amp Accy HF Test.
Manual check of keyboard.*
Manual check of LCD.*
Manual check of keyboard.*
Check for even brightness in LCD
backlight.*
Check sound.*
All TME based tests that apply to the
installed option configuration.
All TME based tests that apply to the
installed option configuration.
Compare serial numbers.*
All tests that apply to the installed
option configuration.
Check time and date.*
165