Keysight Technologies FieldFox N9913A Service Manual page 162

Repair and Replacement Procedures
Removing and Replacing the Measurement Group Assemblies
Reinstalling All Measurement Group Assemblies as One Unit
1. Reinstall the I/O side panel, if needed. Refer to
2. Refer to
3. Reconnect the LCD to System board cable at the System board connector
4. Position the measurement group assemblies on top of the front case and
5. Position (tuck) the LCD to System board cable in between the LCD shield
6. Reconnect the System board to front panel interface board cable at the
162
Panel, Doors, and Gasket" on page
Figure 7-39. Position the measurement group assemblies to the
side of the front case.
and place a strip of adhesive tape over the connector to secure it. This
strip of adhesive tape is provided in the
necessary, refer to "Replacing the A2 LCD, the LCD Shield, and LCD
Cables" on page 132.
align the I/O side panel in the groove in the front case being careful not to
damage the gasket.
and the A5 System board (goes between the speaker side panel) so that it
will not interfere with the cases when they are combined.
front panel interface board connector as shown.
"Replacing the I/O Side
120.
Repair and Re-assembly
Keysight FieldFox Handheld Analyzers Service Guide
Kit. If