Keysight Technologies FieldFox N9913A Service Manual page 149

Repair and Replacement Procedures
Removing and Replacing the Measurement Group Assemblies
15.Remove the System board to FPIB cable (W14) from the old A5 System
16.For N995xA and N996xA models, replace the top panel assembly. Refer to
17.Reinstall the I/O side panel. Refer to
18.Perform the steps under
Keysight FieldFox Handheld Analyzers Service Guide
board and install it on the new board.
"Removing and replacing the RF Top Panel Assembly" on page
and Gasket" on page 120.
"Replacing the I/O Side Panel, Doors,
"Final Assembly Procedure" on page
138.
164.
149