Flash Memory - SATO M84PRO Service Manual

Section 4: Accessories Installation
NOTE: Figures 10-1, 10-2, and 10-3 in the Diagrams & Schematics section
provide guidance on housing cover, media, and ribbon installation.
12 Restore power and test cycle.
FLASH MEMORY INSTALLATION
1 Switch off the printer and disconnect the power supply cord.
2 Open/remove the top, right, and left housing covers.
NOTE: Figure 10-1 in the Diagrams & Schematics section provides guidance
on housing cover removal.
3 Remove three screws (1, Figure 4-3) securing daughter board (2) to main circuit board (3).
4 Disconnect daughter board (2) from circuit board (3).
5 Insert flash card (4) into its reserved brackets on main circuit board (3).
NOTE: The flash card will properly insert into the connector bracket in a
single orientation. Ensure that the contactor side is goes first then press
inward to index the notched areas.
M84Pro Service Manual
5
3
Figure 4-2c, Dispenser Installation
PN: 9001111A
6
7
Page 4-7