Clear Eeprom - SATO M84PRO Service Manual

Section 9: Factory Resets
WARNING: THIS TEST ACTIVATES ALL THE HEATING ELEMENTS ON
THE PRINT HEAD AND THEREFORE SHOULD BE USED FOR TESTING
PURPOSES ONLY. FULL WIDTH LABELS MUST BE USED TO PREVENT
PRINT HEAD DAMAGE.
12 Verify that the counters on the test print have reset to 0.0 km.
13 Power Off the printer and confirm that all switches are in the Off or down position.

CLEAR EEPROM

CAUTION: RESETTING THE PRINTER WILL CLEAR ALL REGISTERS.
1 Record all dip switch positions.
2 Place all dip switches in the OFF position.
3 Place the DSW2-4 in the ON position.
4 Simultaneously, press and hold the LINE and FEED keys while turning on the power switch.
5 Release the LINE and FEED keys upon hearing a beep.
LCD DISPLAY:
6 Place the DSW2-4 in the Off position.
LCD DISPLAY:
7 Press the LINE key to display the next screen.
LCD DISPLAY:
8 Press the FEED key once to display the next screen.
LCD DISPLAY:
9 Press the FEED key once to display the next screen.
LCD DISPLAY:
10 Press the LINE key to scroll to YES.
11 Press the FEED key to clear the EEPROM.
12 Power Off the printer and confirm that all switches are in the Off or down position.
M84Pro Service Manual
INITIALIZING ROM V00.00.00.00
MAINTENANCE MODE DIPSW2-4 ON->OFF
FACTORY MODE
ALL CLEAR MODE
ALL CLEAR COUNTER
EEPROM
COUNTER ALL CLEAR
YES
PN 9001111A
NO
Page 9-5