SATO M84PRO Service Manual page 47

Section 5: Printer Configuration
LCD DISPLAY
MEM SELECT (CC1)
CARD MEMORY
CARD->MEMORYCOPY
TRUETYPEFONT Y/N
COPY START
YES NO
TRUETYPEFONTCOPY
COPYING
TRUETYPE FONTCOPY
COMPLETED
CARD COPY/FORMAT
XXXXXXX ERROR
CARD->MEMORYCOPY
SATOFONT Y/N
COPY START
YES NO
SATO FONT COPY
COPYING
SATO FONT COPY
COMPLETED
CARD COPY/FORMAT
XXXXXXX ERROR
M84Pro Service Manual
This selection determines which type of optional expanded memory will be
addressed as "CC1" in the command streams. The CARD selection specifies
the optional PCMCIA card as CC1 and the optional Expanded Flash ROM as
CC2. The Memory selection specifies the optional Expanded Flash ROM as
CC1 and the optional PCMCIA card as CC2.
1. Use the LINE key to step the cursor to the desired option.
2. Press the FEED key to select the option and advance to the next display
This selection allows TrueType fonts to be copied from the PCMCIA Memory
card installed in the Memory Card slot.
1. Use the LINE key to step the cursor to desired option. If Yes is selected,
the printer will enter the Card Copy mode. If No is selected, the display will
advance to the Card to Memory SATO Font Copy mode.
2. Confirm the selection by stepping the cursor to the Yes option. If No is
selected, the display will return to the previous selection.
3. Press the FEED key to select the option. If Yes was selected the copy
process will begin.
4. Once the copy process is completed, press the FEED key to step the
display.
5. If an error is encountered in the copy process, one of the following
messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory
available.
This selection allows SATO fonts to be copied from the PCMCIA Memory card
installed in the Memory Card slot.
1. Use the LINE key to step the cursor to desired option. If Yes is selected,
the printer will enter the Card Copy mode. If No is selected, the display will
advance to the Card to Memory Copy All mode.
2. Confirm the selection by stepping the cursor to the Yes option. If No is
selected, the display will return to the previous selection.
3. Press the FEED key to select the option. If Yes was selected the copy
process will begin.
4. Press the FEED key to advance to next display.
5. If an error is encountered in the copy process, one of the following
messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory
available.
PN: 9001111A
DEFINITION
Page 5-14