Lcd Panel Printer Configuration - SATO M84PRO Service Manual

Section 5: Printer Configuration
B O
ACKFEED FFSET
When a label is printed it must be correctly positioned for dispensing and application. Thusly, the
printer advances the label stock sufficiently for the printed label to be dispensed. After the label
has been removed for application, the label stock must be withdrawn back into label printing
position. The backfeed function repositions the label stock for printing.
The Backfeed function is enabled if DSW3-4 is in the Off position. When enabled, placing DSW3-
1 in the Off position will cause the backfeed operation to be performed immediately before each
label is printed. If DSW3-1 is in the On position, the backfeed operation is performed as soon as
the dispensed label has been printed and taken from the printer.
The amount of backfeed is controlled by the OFFSET potentiometer on the DIP Switch Panel
inside the cover. The full adjustment range is +/- 3.75 inches from nominal. The backfeed
adjustment procedure is as follows:
1. Turn the printer on.
2. Press the LINE key to place the printer in the Off-Line status.
3. Press the FEED key to feed out a blank label while observing the dispensement position.
4. Adjust the OFFSET potentiometer on the front control panel as deemed necessary.
5. Repeat steps 4 and 5 until a label is fully released from the liner.
D
ISPLAY
This potentiometer is used to adjust the contrast of the LCD display for optimum viewing under
various lighting conditions.
P
RINT
The PRINT potentiometer is used to adjust the amount of heat (i.e., power) applied to the head
for printing. It provides a continuous range of adjustment. Maximum print darkness is obtained by
turning the potentiometer all the way clockwise and a maximum counterclockwise setting will give
the lightest print.
NOTE: Adjustment of the PRINT potentiometer will affect the darkness in all
of the command code, speed, and darkness ranges.

LCD PANEL PRINTER CONFIGURATION

The LCD Panel allows the printer to communicate with the operator. The operator communicates
with the printer largely through the use of the LINE and FEED keys. Many settings may also be
controlled via software commands. Where software commands and control panel settings
conflict, the printer will always use the last valid setting.
There are seven modes of operation. To enter the desired mode, the KEY SEQUENCE
combination listed in the table below must be performed. The initial LCD display message is
shown for each mode.
M84Pro Service Manual PN 9001111A Page 5-9