SATO M84PRO Service Manual page 38

Section 5: Printer Configuration
Status Select(DSW2-8): For emulating earlier series software commands. Should be used only
if problems are encountered when using existing software. This switch will also affect the settings
selected by DSW1-7 and DSW1-8.
DSW2-8 SETTING
Off Status 3 & 4 Enabled
On Status 2 & 3 Enabled
Backfeed Sequence (DSW3-1, DSW3-2): Backfeed is used to correctly position the label for
application and then retract the next label to the proper print position. This operation can be
performed immediately after a label is printed and used, or immediately prior to the printing of the
next label.
DSW3-1
Off Off
Off On
On Off
On On
* Defaults to Continuous if cutter not
installed
Label Sensor Selection (DSW3-3): Enables or disables the Label Sensor. If the Sensor is
enabled, it will detect the edge of the label and position it automatically. If it is disabled, the
positioning must be under software control using Line Feed commands.
DSW3-3 SETTING
Off Sensor Used
On Not Used
M84Pro Service Manual
DSW2
ON
OFF
SETTING DSW3
ON
Continuous
Tear-Off
OFF
Cutter*
Dispenser
DSW3
ON
OFF
PN 9001111A
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
8
8
8
Page 5-5