SATO M84PRO Service Manual page 48

Section 5: Printer Configuration
LCD DISPLAY
MEMORY->CARDCOPY
ALL <0MB> Y/N
COPY START
YES NO
CARD->MEMORY
COPY COPYING
CARD->MEMORYCOPY
COMPLETED
CARD COPY/FORMAT
XXXXXXX ERROR
MEMORY->CARDCOPY
ALL <0MB> Y/N
COPY START
YES NO
MEMORY->CARDCOPY
COPYING
MEMORY->CARDCOPY
COMPLETED
CARD COPY/FORMAT
XXXXXXX ERROR
CARD->MEMORYCOPY
PROGRAM Y/N
COPY START
YES NO
CARD->MEMORY
COPY COPYING
M84Pro Service Manual
This selection allows the entire contents from the optional Expanded Memory
to be copied to the PCMCIA Memory card installed in the Memory Card slot.
1. Use the LINE key to step the cursor to desired option. If Yes is selected,
the printer will enter the Card Copy mode. If No is selected, the display will
advance to the Card to Memory Copy All mode.
2. Confirm by stepping the cursor to the Yes option. If No is selected, the
display will return to the previous selection.
3. Press the FEED key to select the option. If Yes was selected the copy
process will start.
4. Press the FEED key to advance to the next display.
5. If an error is encountered in the copy process, one of the following
messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory
available.
This selection allows the entire contents of the optional Expanded Memory to
be copied to the PCMCIA Memory card instaled in the Memory Card slot.
1. Use the LINE key to step the cursor to desired option. If Yes is selected,
the printer will enter the Card Copy mode. If No is selected, the display will
advance to the Card to Memory Copy All mode display.
2. Confirm the selection by stepping the cursor to the Yes selection. If No is
selected, the display will return to the previous selection.
3. Press the FEED key to select the option. If Yes was selected the copy
process will begin.
4. Once the copy process is completed, press the FEED key to step the
display.
5. If an error is encountered in the copy process, one of the following
messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory
available.
This selection allows the printer firmware to be copied from the PCMCIA
Memory Card to the printer.
1. Use the LINE key to step the cursor to desired option. If Yes is selected,
the printer will enter the Card Copy mode. If No is selected, the display will
advance to the mode display.
2. Confirm the selection by stepping the cursor to the Yes option. If No is
selected, the display will return to the previous selection.
3. Press the FEED key to select the option. If Yes was selected the copy
process will begin.
PN 9001111A
DEFINITION
Page 5-15