Factory Settings/Test Print - SATO M84PRO Service Manual

FACTORY RESETS
This section of the service manual covers instructions on how to return the printer to its factory
settings. The instructions are separated into differing categories of interest.
FACTORY SETTINGS / TEST PRINT
CAUTION: RESETTING THE PRINTER WILL CLEAR ALL REGISTERS.
1 Record all dip switch positions.
2 Place all dip switches in the OFF position.
3 Place the DSW2-4 in the ON position.
4 Simultaneously, press and hold the LINE and FEED keys while turning on the power switch.
5 Release the LINE and FEED keys upon hearing a beep.
LCD DISPLAY:
6 Place the DSW2-4 in the Off position.
LCD DISPLAY:
7 Press the FEED key to display the next screen.
LCD DISPLAY:
8 Press the LINE key once to change the message from NONE to ALL.
LCD DISPLAY:
9 Press the FEED key to clear the EEPROM.
LCD DISPLAY:
10 Select the print label size by pressing the LINE key.
NOTE: The default selection is large. The LINE key allows scrolling from one
option to another.
M84Pro Service Manual
INITIALIZING ROM V00.00.00.00
MAINTENANCE MODE DIPSW2-4 ON->OFF
FACTORY MODE
COUNTER CLEAR - NONE
COUNTER CLEAR - ALL
PRINT SIZE
SMALL LARGE
PN: 9001111A
9
Page 9-1