SATO M84PRO Service Manual page 55

Section 5: Printer Configuration
The Test Print Mode offers 4 different status labels for troubleshooting. If DSW3-5 is in the OFF position,
the Test Print cycle must be initiated with a Print Start signal on the EXT connector You enter the Test
Print Mode by pressing the FEED key while powering the printer on.
LCD DISPLAY
V 05.00.03.00
INITIALIZING
TEST PRINT MODE
CONFIGURATION
TEST PRINT SIZE
10 CM
PRESS FEED KEY TO
STOP PRINTING
.
Occassionally it is desirable to reset all printer configuration settings to their original default conditions.
This allows the operator to start reconfiguration of the printer starting from a know set of conditions.
LCD DISPLAY
V 05.00.03.00
INITIALIZING
DEFAULT SETTING
YES NO
M84Pro Service Manual
TEST PRINT MODE
Displays the firmware during the initialization.
This option allows printing of a test label. It is recommended that a test label
be printed after the settings in the Advanced Mode have been changed. The
test label provides verification that the correct changes were entered.
1. Press the FEED key while switching on the power switch to access the
Test Print Mode.
2. Release the FEED key when the printer beeps.
3. Use the CURSOR keys to step the cursor to the test label type option
desired. They are:
CONFIGURATION
BARCODE
HEADCHECK
MEMORY
FACTORY
4. Press the FEED key to select the desired option.
Note: This screen will not be displayed for the Memory Test Label.
This display allows label width selection.
1. Use the LINE key to step to the desired label width option.
2. Press the FEED key to select the option.
3. Press the FEED key to start printing test labels continuously.
4. Press the FEED key to stop the printer.
5. To exit the Test Print Mode, power the printer off and then back on.
DEFAULT SETTINGS MODE
Displays the firmware during the initialization.
Allows the reset of original printer default settings. Enter the Default Setting
Mode by:
1. Press and hold the LINE and FEED keys while switching on power.
1. Release the LINE and FEED key when the printer emits one long beep.
1. Use the LINE key to step to either the YES or NO option.
2. Press the FEED key to select the desired option.
PN: 9001111A
DEFINITION
DEFINITION
Page 5-22