SATO M84PRO Service Manual page 84

Section 7: Replacement Procedures
7 Remove screw (11, Figure 7-12c) and loosen screw (12) to free pulley tension bracket (13).
8 Remove platen roller belt (14) and ribbon rewind belt (15) from feed roller pulley (16) and
platen roller pulley (17) respectively.
NOTE: Remove e-clips (18) if removal or replacement of pulleys (16) and
(17) is required.
9 Remove two screws (19, Figure 7-12d) and four screws (20) and withdraw ribbon frame
(21).
10 Remove ribbon rewind belt (15) from ribbon rewind spindle pulley (22).
11 Prepare to replace timing belts (3), (4), (14), and (15).
12 Apply replacement belt (15) to pulley (22) and allow to suspend.
13 Apply ribbon frame (21) to the printer frame and secure using four screws (20) and two
screws (19).
M84Pro Service Manual
12
16
Figure 7-12c, Platen Roller Belt Replacement
PN 9001111A
17
14
13
13
15
18
11
11
Page 7-16