Cutter Circuit Board - SATO M84PRO Service Manual

Section 7: Replacement Procedures
CUTTER CIRCUIT BOARD REPLACEMENT
1 Switch off the printer and disconnect the power supply cord.
2 Remove cutter assembly (1, Figure 7-24) from the printer.
NOTE: If unsure how to remove the cutter assembly, refer to the Label Cutter
Installation procedure in the Accessories Installation section for guidance.
3 Disconnect all wiring harnesses from circuit board (2).
4 Remove two screws (3) from paper guide plate (4).
NOTE: The two screws that are to be removed from the paper guide plate are
located on the front side of the cutter along the lower perimeter of the plate.
CAUTION: WHEN THE TWO SCREWS ARE REMOVED FROM THE
PAPER GUIDE PLATE, TWO NYLON SPACERS LOCATED BETWEEN
THE CIRCUIT BOARD AND THE PLATE WILL BE FREED. ENSURE THAT
THE CUTTER ASSEMBLY IS HORIZONTAL WITH THE CIRCUIT BOARD
ORIENTED UPWARD WHEN THE BOARD IS REMOVED TO PREVENT
THEIR LOSS.
7
6
5
A
2
M84Pro Service Manual
2
D
B
C
D
Figure 7-24, Cutter Circuit Board Replacement
PN: 9001111A
A
8
C
1
3
B
Page 7-27