SATO M84PRO Service Manual page 26

Section 4: Accessories Installation
NOTE: Figures 10-1, 10-2, and 10-3 in the Diagrams & Schematics section
provide guidance on housing cover, media, and ribbon removal respectively.
3 Remove the ribbon and label stock if applicable and leave the print head open.
4 Remove screw (1, Figure 4-2a) securing front cover (2) to the printer frame. Lift away front
cover (2).
NOTE: The screws are accessible at the rear of the cover on the right side.
Manipulate the cover upward and outward to remove.
5 Route dispenser wiring harness (3) through the slot in the printer side wall.
CAUTION: WHEN ROUTING THE WIRING HARNESS, ENSURE THAT IIS
ROUTED IN A MANNER SO AS TO PREVENT PINCHING OR
INTANGLEMENTS.
M84Pro Service Manual
2
Figure 4-2a, Dispenser Installation
PN: 9001111A
1
Page 4-5