Section 7: Replacement Procedures
3
4
9
4
Loosen two screws (2) to release belt tension on drive roller (1).
5
Loosen or remove two screws (3) securing clamp (4) to the right end of drive roller (1).
6
Remove e-clip (5) and the outer belt (not shown) from the left end of drive roller (1) and pul-
ley (6).
7
Withdraw pulley (6) from left drive roller spindle and inner belt (not shown).
8
Loosen screw (7) and clamp (8) on the left end of drive roller (1).
9
Withdraw drive roller (1) along with left and right bushings (9) from the printer.
10
Assemble replacement roller as required with bushings (9).
NOTE: The bushings must be installed onto the ends of drive roller with their
flanged sides oriented outward. The pulley must be installed so its wider
sleeve is oriented outward.
M84Pro Service Manual
Figure 7-11, Feed Roller Replacement
PN:
9001111A
2
1
7
9
8
5
6
Page 7-13