Section 9. Optional Accessories
Flash Memory Expansion Installation
NOTE: Many of the components on this board are susceptible to damage by static
electricity. To avoid damage, do not unpack new circuit boards from anti-static bags
until instructed to do so and use a wrist grounding strap.
STEP
PROCEDURE
4.
Carefully press outward on the tabs on both ends of the Main PCB Board
Memory .rame to release the Standard Memory PCB. The Standard
Memory PCB should lift by itself when released. Remove the Memory
PCB from the frame. Note the indexing notches. .igs. 9-39
5.
Remove the .lash Memory Module from the anti-static bag handling the
module by the edges. Note the indexing notches. Insert the module into
the Main PCB Memory .rame at approximately 45
PCB Board. Gently push down to snap into position. .igs. 9-40
6.
Replace the cover reversing removal steps.
7.
Complete the .actory Reset Procedure.
PRESS OUTWARD
*
PRESS OUTWARD
*
Page 9-24
STANDARD MEMORY PCB IN THE
MAIN PCB MEMORY FRAME
Figs. 9-39
*
CAREFULLY PRESS OUTWARD
ON TABS ON BOTH ENDS OF THE
FRAME TO RELEASE THE MEMORY
SATO CL408e/CL412e Service Manual
0
away from the Main
INDEXING NOTCHES
PCB.
PN 9001078
Rev. A