Section 7: Replacement Procedures
5
Remove belt from the motor shaft and withdraw motor (1) to the media side of the printer.
6
Disconnect wiring harness (3) from motor (1).
7
Remove two screws (4) securing damper (5) and heat plate (6) to motor (1).
8
Lift away damper (5), heat sink (6) and withdraw motor (1) from within the printer frame.
NOTE: The damper and heat plate must be removed from the motor for the
motor to be withdrawn from within the printer frame. Likewise, the damper
and heat plate must be mounted to the replacement motor with the motor
positioned within the frame.
9
Insert the replacement motor (1) within the printer frame under the label ramp.
3
M84Pro Service Manual
1
6
5
4
Figure 7-9, Motor Replacement
PN 9001111A
2
Page 7-10