SATO M84PRO Service Manual page 105

Section 8: Adjustment Procedures
6 Loosen two screws (10) and manipulate bracket (11) to tighten ribbon rewind belt (12).
Retighten screws (10).
NOTE: The lower roller may be adjusted by inserting a medium sized
standard screwdriver into the slot located along the lower periphery of the
roller bracket and twisting. The scale is located adjacent to the adjustment
slot.
7 Restore power and test cycle to ensure proper function.
8 Close/replace housing covers.
NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance
on housing cover installation.
PITCH SENSOR SETUP FOR NOTCH TAGS
The following procedure applies to labels with notches along the left perimeter of the label stock.
Ignore this procedure otherwise.
1 Switch off the printer and disconnect the power supply cord.
2 Remove the front housing cover.
NOTE: Figure 10-1 in the Diagrams & Schematics section provides guidance
on housing cover removal.
3 Remove e-clip (1, Figure 8-7) from brass sensor adjustment shaft (2) as necessary.
NOTE: Removal of the e-clip permits the sensor to be adjusted an additional
14mm to the left for tag stock applications.
M84Pro Service Manual
4
3
1
Figure 8-7, Pitch Sensor Assembly
PN: 9001111A
2
Page 8-9