Dispenser - SATO M84PRO Service Manual

Section 4: Accessories Installation
16 Place DSW3-1 in the up position and the DSW3-2 in the down position.
17 Load the printer with ribbon and media stock and close/install all housing covers.
NOTE: Refer to Figures 10-1, 10-2, and 10-3 in the Diagrams & Schematics
section for housing cover, media, and ribbon installation respectively.
18 Restore power and test cycle.
DISPENSER INSTALLATION
Installation of the optional label dispenser into the printer adds the convenience of automatic
label dispensing. Each label is printed, then peeled from the backing paper and presented at the
front of the printer for removal by the operator. A photo-electric sensor detects the presence of a
completed label and signals the printer to automatically backfeed the label stock for correct
alignment of the next print cycle.
NOTE: Refer to Figure 10-5, Accessories & Sensors Location in the
Diagrams & Schematics section if assistance is needed.
1 Switch off the printer and disconnect the power supply cord.
2 Open/remove the top, right, and left housing covers.
M84Pro Service Manual
13
14
11
Figure 4-1c, Label Cutter Installation
PN 9001111A
12
15
16
Page 4-4