Clear Cutter Counter - SATO M84PRO Service Manual

Section 9: Factory Resets
WARNING: THIS TEST ACTIVATES ALL THE HEATING ELEMENTS ON
THE PRINT HEAD AND THEREFORE SHOULD BE USED FOR TESTING
PURPOSES ONLY. FULL WIDTH LABELS MUST BE USED TO PREVENT
PRINT HEAD DAMAGE.
12 Verify that the counters on the test print have reset to 0.0 km.
13 Power Off the printer and confirm that all switches are in the Off or down position.

CLEAR CUTTER COUNTER

CAUTION: RESETTING THE PRINTER WILL CLEAR ALL REGISTERS.
1 Record all dip switch positions.
2 Place all dip switches in the OFF position.
3 Place the DSW2-4 in the ON position.
4 Simultaneously, press and hold the LINE and FEED keys while turning on the power switch.
5 Release the LINE and FEED keys upon hearing a beep.
LCD DISPLAY:
6 Place the DSW2-4 in the Off position.
LCD DISPLAY:
7 Press the FEED key to display the next screen.
LCD DISPLAY:
8 Press the LINE key twice to change the message from NONE to CUT.
LCD DISPLAY:
9 Press the FEED key to clear the cutter counter.
LCD DISPLAY:
10 Select the print label size by pressing the LINE key.
NOTE: The default selection is large. The LINE key allows scrolling from one
option to another.
11 Press the FEED key to test print. Press the FEED key again to stop printing.
M84Pro Service Manual
INITIALIZING ROM V00.00.00.00
MAINTENANCE MODE DIPSW2-4 ON->OFF
FACTORY MODE
COUNTER CLEAR - NONE
COUNTER CLEAR - CUT
PRINT SIZE
SMALL LARGE
PN: 9001111A Page 9-4