Daikin ACS320 Operation Manual page 15

Operating the Drive
Auto/Hand – The very first time the drive is powered up, it is
in the auto control (AUTO) mode, and is controlled from the
Control terminal block X1 .
To switch to hand control (HAND) and control the drive using
the control panel, press and hold the (HAND)
button .
• Pressing the HAND button switches the drive to hand
control while keeping the drive running .
• Pressing the OFF button switches to hand control and
stops the drive .
To switch back to auto control (AUTO), press and hold the
button .
Hand/Auto/Off – To start the drive press the HAND or AUTO
buttons, to stop the drive press the OFF button .
Reference – To modify the reference (only possible if the
display in the upper right corner is in reverse video) press the
UP or DOWN buttons (the reference changes immediately) .
The reference can be modified in the local control mode, and
can be parameterized (using Group 11 reference select,
39) to also allow modification in the remote control mode.
NOTE: The Start/Stop, Shaft direction and Reference
functions are only valid in local control (LOC) mode .
www .DaikinApplied .com
or (OFF)
page
15
s u
TarT p
OM 1190-1 • MD4 VFD