MiiNePort E1/E2-SDK
SCM (Serial Command Mode)
The MiiNePort E1/E2-SDK's SCM (Serial Command Mode) allows the module's parameters to be retrieved or
configured through the serial port, rather than over the network. This is done through the use of specially
parsed commands sent to the module through the serial port.
SCM is often used when your device has already been used in actual applications and you need to change the
MiiNePort E1/E2-SDK's configuration, such as changing the device's IP address by using your device's keypad.
The details are shown below:
6-2
NetEZ Technologies