Table of Contents
Advertisement
MiiNePort E1/E2-SDK
Netmask
Setting
E.g., 255.255.255.0
A subnet mask represents all the network hosts at one geographic location, in one building, or on the same
local area network. When a packet is sent out over the network, the module will use the subnet mask to check
whether the host specified in the packet is on a local network segment. If the address is on the same network
segment as the module, a connection is established directly from the module. Otherwise, the connection is
established through the default gateway.
Gateway
Setting
E.g., 192.168.1.1
A gateway acts as an entrance to another network. Usually, the computers that control traffic within the
network or at the local Internet service provider are gateway nodes. The module needs to know the IP address
of the default gateway computer in order to communicate with the hosts outside the local network environment.
For correct gateway IP address information, consult your network administrator.
DNS server 1 / DNS server 2
Setting
E.g., 192.168.1.1
(IP addresses of the
form x.x.x.0 and
x.x.x.255 are invalid)
Domain Name System (DNS) is how Internet domain names are identified and translated into IP addresses. A
domain name is an alphanumeric name, such as moxa.com, that it is usually easier to remember. A DNS server
is a host that translates the text-based domain name into the corresponding numeric IP address which is used
to establish a TCP/IP connection. When the user enters a website address, the computer asks a DNS server for
the website's IP address to connect to the web server.
When a DNS server is specified, the module acts as DNS client and will allow domain names instead of IP
addresses to be used on the web console. The following web console fields support the use of domain names:
TCP Client-Destination IP Address, and IP Address Report Server. Two DNS servers may be specified, DNS
server 1 and DNS server 2. DNS server 2 is included for use when DNS server 1 is unavailable.
The Next page is about serial parameters settings, all serial parameters settings can be adjusted in this page.
Factory Default
255.255.255.0
Factory Default
None
Factory Default
None
5-15
MiiNePort IDE Development Tool
Recommended Setting
Required
Recommended Setting
Optional
Recommended Setting
Optional
Advertisement
Table of Contents
