Table of Contents
Advertisement
MiiNePort E1/E2-SDK
Connecting Power
For MiiNePort E1-SDK Evaluation Board Layout
Connect the 12-48 VDC power line with the power jack of the evaluation board. If the power is properly
supplied, the power LED (D15, as shown in the following figure) on the evaluation board will show a solid red
color until the system is ready, at which time the ready LED on the module will show a solid green color.
For MiiNePort E2-SDK Evaluation Board Layout
Connect the 12-48 VDC power line with the evaluation board's power jack. If the power is properly supplied, the
power LED on the evaluation board (D14) will show a solid green color until the system is ready. When the
system is ready, the ready LED on the module will show a solid green color.
Connecting MiiNePort USB to PC
First, connect the MiiNePort USB port to the PC. Please use the USB cable to connect the USB port on the
evaluation board to the PC. The figures below indicate the location of the USB port on the evaluation board.
E1 Evaluation Board
2-3
Getting Started
Advertisement
Table of Contents
