Moxa Technologies MiiNePort E1-SDK User Manual page 50

MiiNePort E1/E2-SDK
Baudrate
Setting
50 bps to 921.6 Kbps
IP configuration is a required field. The default setting is Static.
ATTENTION
Baudrate 460800 and 921600 are for High speed model only. If you don't want to use High speed mode, please
remove jumper first.
Data Bits
Setting
5, 6, 7, 8
Stop Bits
Setting
1, 1.5, 2
Stop Bits will be set to 1.5 when Data Bits is set to 5 bits.
Parity
Setting
None, Even, Odd,
Space, Mark
Flow control
Setting
None, RTS/CTS,
DTR/DSR, XON/XOFF
FIFO
Setting
Enable, Disable
Each module's serial port provides a 16-byte FIFO both in the Tx and Rx directions. Disable the FIFO setting
when your serial device does not have a FIFO to prevent data loss during communication.
Factory Default
115200
Factory Default
8
Factory Default
1
Factory Default
None
Factory Default
RTS/CTS
Factory Default
Enable
5-16
MiiNePort IDE Development Tool
Recommended Setting
Required
Recommended Setting
Required
Recommended Setting
Required
Recommended Setting
Required
Recommended Setting
Required
Recommended Setting
Required