Table of Contents
Advertisement
MiiNePort E1/E2-SDK
Panel Layout
MiiNePort E1-SDK Evaluation Board Panel Layout
ATTENTION
Users must set jumpers JP15, JP16, and JP17 to correspond with the functions of pins 6, 7, and 8,
respectively, to ensure that the evaluation board works properly.
ATTENTION
When you are in RS-485 mode, 485EN must be configured by either JP15 or JP16, and the 6-pin jumper must
be moved from JP19 to JP20.
Number
Description
1
MiiNePort E1 Module Location
2
USB Type B Connector (Debug)
3
Configurable Pin Jumper
4
Digital Input Switch
5
Digital Output LED
6
Digital IO Terminal Block
7
Serial Port Status LED
8
DB9 Male Connector
9
Serial Interface Jumper
10
Power LED
11
Power Jack
12
Restart Button
13
Circuit Pad
1-3
Introduction
Advertisement
Table of Contents
