Do Safe Mode Settings; Ao Safe Mode Settings - Moxa Technologies ioLogik E1200 Series User Manual

ioLogik E1200 Series
Client settings:
Note: refer to the table below for maximum number of rules supported at different signal frequencies.
1 rule
10 rules
20 rules
30 rules
40 rules
50 rules

DO Safe Mode Settings

When a peer-to-peer rule on a local DO channel is not valid, the local DO channel will enter safe mode. You can
set the DO to be Hold Last, ON, or OFF in safe mode.

AO Safe Mode Settings

When a peer-to-peer rule of the local AO channel is not valid, the local AO channel will enter safe mode. You can
either set the AO safe value from 0-4095 or enable Hold Last Status during Safe Mode.
1 Hz 2 Hz
 
 
 
 
 

3-15
Using the Web Console
4 Hz 10 Hz
 


20 Hz
