Command Code; Command Code For Getting The Configuration - Moxa Technologies MiiNePort E1-SDK User Manual

MiiNePort E1/E2-SDK

Command Code

Command Code for Getting the Configuration

Device Name
Command code: BN
Command parameters: N/A
Reply parameters: MiiNePort's name.
?GBN
!GBN0MiiNePort_E1_9527
IP configuration
Command code: NC
Command parameters: N/A
Reply parameters: MiiNePort's IP configuration index as follows.
0 Static
1 DHCP
2 DHCP/BOOTP
3 BOOTP
4 AUTOIP
?GNC
!GNC00
IP address
Command code: NI
Command parameters: N/A
Reply parameters: MiiNePort's IP address.
?GNI
!GNI0192.168.127.254
Netmask
Command code: NM
Command parameters: N/A
Reply parameters: MiiNePort's Netmask address.
?GNM
!GNM0255.255.255.0
Introduction to SCM (Serial Command Mode) Command Set
System requests configured device name for this MiiNePort.
MiiNePort reports device name as MiiNePort_E1_9527
System requests IP configuration for this MiiNePort.
MiiNePort reports IP configuration as 'Static'.
System requests IP address for this MiiNePort.
MiiNePort reports IP address as '192.168.127.254'.
System requests Netmask address for this MiiNePort.
MiiNePort reports netmask as '255.255.255.0'.
A-3