Table of Contents
Advertisement
TresCon UNO
Designation of the
modules
T0GCURVEXX.XX.XX,
YY.YY.YY,ZZ,T1(,T2)
T0GMEANXX.XX.XX,
T1(,T2)
ba43134e08
05/2017
8.4
Interface commands
8.4.1 General RS commands
In the interface commands, the modules are labeled with Tx as follows:
T0 = terminal
T1 = analyzer module
T2 = secondary measured value of the analyzer module if it provides
one (example: SAC value at the TresCon NOx-N/SAK analyzer
module).
All RS commands for the terminal start with T0.
Note
The RS commands of the individual modules are given in chapter 7
A
of the module-specific sections of this operating manual.
PPENDIX
The graph in the time period xx:xx:xx to yy:yy:yy is printed. T1 is speci-
fied if module T1 should be printed, etc.
Example see "D
AILY
The mean values from xx:xx:xx are printed. T1 is indicated if the T1
component should be printed etc. Only one component can be printed.
-----------------------------------------
Module 1
Reference day
Reference period for calculation
24:00
Mean value
12.13 mg/l PO4-P
Min. value
Max. value
17.3
Min. time
03:32 hours
Max. time
12.38 hours
-----------------------------------------
-----------------------------------------
TresCon>
/
WEEKLY LOAD DIAGRAM
18.7.03
00:00 -
9.2
mg/l PO4-P
mg/l PO4-P
Appendix
" on page 5-14.
8 - 11
Advertisement
Table of Contents
