Recorder Function, Control - wtw TresCon UNO A111 Operating Manual

TresCon UNO
Controller setting menu
Characteristic curve
ba43134e08 05/2017
Note
The setting of the recorder parameters is described in section
5.4.2 S
ETTING UP THE RECORDER

5.4.5 Recorder function, Control

With the Control function, you can use the recorder as a control output.
Depending on the measured value, TresCon outputs a current value
that follows the defined characteristic curve. With this, actuators of any
kind can be operated.
Using the two value pairs, C1/I1 and C2/I2, the slope and the lower and
upper current limit are determined.
Current I [mA]
I1
I2
0
C1
Fig. 5-19 Characteristic curve of a control device (negative characteristic curve)
.
Measured value
C2
Operation
5 - 57