Table of Contents
Advertisement
Installation
Pre-assembling the
component
Mounting the
component on the
TresCon UNO
3 - 24
3.6.2 Installing the overflow vessel with valve
The overflow vessel with valve is screwed to the mounting element of
the TresCon UNO instead of the series overflow vessel.
Using a piece of Norprene tube (inner diameter 9.5 mm), connect the
overflow vessel and the valve. Place the preassembled components on
the left position of the mounting plate (see Fig. 3-21).
1
Remove the lid of the overflow vessel.
2
Screw the overflow vessel and the magnetic valve on the
mounting plate.
M5 x 8
Fig. 3-21 Pre-mounting the TC/ÜB V
3
Close the lid of the overflow vessel.
4
Switch off the TresCon UNO.
5
Remove the installed overflow vessel from the mounting ele-
ment.
M4 x 20
ba43134e08
TresCon UNO
05/2017
Advertisement
Table of Contents
