Initial Commissioning; Checklist For Initial Commissioning; Switching On - wtw TresCon UNO A111 Operating Manual

TresCon UNO
Switching on the
TresCon UNO
ba43134e08 05/2017
4

Initial commissioning

4.1

Checklist for initial commissioning

 Is the waste water connection installed?
 Is the outlet of the tray connected?
 Is the sample feed connected?
 Is the electrical connection according to regulations?
 Are the (optional) peripheral devices (relay connections, recorder,
etc.) connected?
Note
Please read section 5.1 B
before you start the following steps for the initial commissioning.
4.2

Switching on

1 Start the preparatory activities according to the checklist.
2 Open the enclosure door.
3 Use the mains switch to switch on the TresCon UNO
(position I). The analyzer module is heated to the temperature
that was set.
TresCon P04-P
TresCon
Ser.-Nr. 00110010
WTW 82362 Weilheim Made in Germany
TresCon PO4-P
Ablauf
Pumpschlauch Standard/Probe
blau / blau / blau
Pumpschlauch Reagenz
orange / gelb / orange
P1 P2 Thermoblock
blau grün green rot red P3 Pump Tube Standard/Sample
blue blue / blue / blue
V2 V4 Pump Tube Reagent
orange / yellow / orange
V1 V3
blau gelb orange grün
blue yellow orange green
Probe Reinigungslösung H O dest. 2 Standard B Reagenz
Sample Cleaning Solution H O dest. 2 Standard B Reagent
Fig. 4-1 Power switch
ASIC PRINCIPLES OF OPERATION
power switch
Initial commissioning
, page 5-1
4 - 1