Transmitting Data (Usb Interface); Options For Data Transmission - wtw Avantor VWR pH 1100 L Operating Manual

Operation
52
5.6

Transmitting data (USB interface)

5.6.1 Options for data transmission

Via the USB interface you can transmit data to a PC. The following
table shows which data are transmitted to the interface in which way:
Data
Current
measured values
of all connected
sensors
Stored measured
values
Calibration
records
Note
The following rule applies: With the exception of the menus, shortly
<F2>
pressing the /[USB output] key generally outputs the display con-
tents to the interface (displayed measured values, measurement data-
sets, calibration records).
Control Operation / description
 With
Manual
 Simultaneously with every
 With
Automatic, at
intervals
 Simultaneously with every
 Displayed dataset with
Manual
 All datasets with the Output
For details, see section 5.5.3.
 Calibration record with
Manual
For details, see section 5.6.
 At the end of a calibration
Automatic
pH 1100 L
<F2>
/[USB output].
manual storage process
(see section 5.5.1).
<F2__>
/[USB output].
Then you can set the trans-
mission interval.
Note:
For operation with MultiLab
pilot: set the Send ID option
to No (see section 5.7).
automatic storage process
(see section 5.5.2).
<F2>
/[USB output] after
calling up from the memory.
to USB function.
<F2>
/[USB output].
procedure.
ba77068d05 05/2021