IN220 Cylindrical Lock
Operational Check
8
1. Insert key into cylinder and rotate (Fig. 14A).
There should be no friction against lock case, wire
harness or any other obstructions.
2. Check that the key retracts the latch.
3. The key should rotate freely.
4. Try the inside lever; ensure it retracts latch.
5. Use a valid credential* set up with the Lock
Configuration Tool to unlock outside lever and
retract latch.
Refer to Network and Lock Configuration
Tool user manual (WFMN1) for information on
how to configure and program locks.
Fig. 14A
Note: The credential should approach the inscription
on the reader as indicated (Fig. 14B) to ensure
the credential is read properly.
Do not wave credential.
Fig. 14B
1-800-810-WIRE • www.sargentlock.com • A8203A
23