IN220 Cylindrical Lock
12 Installation of Inside Module Component Assembly
1. Insert top tabs of controller into slots on mounting plate (Fig. 12A, B).
2. Ensure proper alignment of board-to-board connectors while pivoting bottom
of controller toward door until tab on bottom snaps securely into place on
mounting plate.
CAUTION: To avoid possible damage to board-to-board connectors,
care should be taken when securing controller to mounting
plate. If there is resistance when securing, detach controller
to determine cause before re-attaching controller.
3. Connect RJ45 male connector to female RJ45 on controller board (Fig. 12B).
Fig. 12A
1-800-810-WIRE • www.sargentlock.com • A8203A
Fig. 12B
4. Remove pull tab from its position
beneath the coin cell by pulling
on tab in direction of arrows
printed on tab (Fig. 11B).
21