Operational Check - Sargent ASSA ABLOY IN100 Series Installation Instructions Manual

6 Lock Installation continued
12 Install inside cover (Figure 22)
a. Assemble cover by hooking top
edge on inside mounting plate.
b. Carefully press bottom of cover
toward door without pinching or
damaging wires.
c. Secure cover utilizing security allen
wrench (provided).
7

Operational Check

For mortise locks with cylinders:
1. Insert key into cylinder and rotate.
(Figure 23)
NOTE: There should be no friction
against lock case, wire harness or any
other obstructions.
2. Check that key retracts latch.
NOTE: Key should rotate freely.
3. Throw deadbolt, if present. Check that
key retracts both deadbolt and latch.
4. Try inside lever; ensure it retracts latch
and deadbolt, if provided.
5. Present a valid credential* to unlock
outside lever; turn lever handle to
ensure latch retracts. (Figure 24)
NOTE: Credential should approach
inscription on reader as indicated to
ensure credential is read properly. Do
not wave credential. (Figure 24)
*Depending upon availability of access control
system either a (denied) red flash or a green
and lock motor cycle (access granted).
Fig. 13A
18 1-800-810-WIRE • www.sargentlock.com • A8190E
IN100 Series
Mortise Lock
Installation Instructions
Inside
Cover
Security
Allen Screw
Fig. 12
Fig. 13B