Sargent IN220 Installation Instructions Manual page 12

2 Install Strike
Install strike in the door frame (Fig. 2).
3 Install Latchbolt
1. Install latch with beveled bolt facing the strike.
2. Attach with two screws but DO NOT tighten completely at this time.
See step 8 - Secure Lock to Door.
IMPORTANT: Latch bevel must match door bevel and
deadlocking latch must stop on strike when door is closed.
IMPORTANT:
• Door must remain open during installation.
Use door stop.
4 Install Door Position Switch (DPS)
1. Push wires through raceway toward lock prep.
2. Push DPS firmly into place by hand.
Note: DO NOT TAP SWITCH WITH ANY TOOL.
3. Install magnet into door frame. Push firmly into place by hand.
See A7983.
4. To connect DPS to lock controller per diagram, refer to the wiring in
Step #14 section 3.
CAUTION: if DPS is not installed or is installed
improperly, door status monitoring features will
not function.
12 1-800-810-WIRE • www.sargentlock.com • A8203A
Strike
Deadlocking Latch
Fig. 3B
(Door Position Switch)
IN220 Cylindrical Lock
Centerline of Latch
(2) #8-32 x 3/4"
Latch Screws
DPS
Front and Strike
Fig. 2
Inside of Door
PoE Harness
(Cat 5e and
ground)
Fig. 3A
Inside of Door
Fig. 4