Sargent IN220 Installation Instructions Manual page 16

7 Install Lock
1. From outside of door, feed lock body harness into the lock body hole (Fig. 7A).
For metal door: Feed harness through inside of door (not shown).
2. Continue to feed harness into raceway (towards top of door), exiting raceway
hole on inside of door (Fig. 7B).
3. Slide lock body into cross-bore hole from outside of door.
4. Lock body must engage both the latch unit prongs and tail piece (Fig. 7C).
IMPORTANT:
• Door must remain open during installation (use door stop).
• Lock body must be centered in the door.
• Tuck excess wires into raceway to avoid pinching wires.
NOTE: Cable lengths exaggerated for illustrative purposes.
16 1-800-810-WIRE • www.sargentlock.com • A8203A
Inside of Door
Fig. 7B Detail
Fig. 7C Detail
Outside of Door
PoE
Harness
(Cat 5e)
Ground Ring
Terminals
IN220 Cylindrical Lock
Fig. 7A