Sargent IN220 Installation Instructions Manual page 10

PoE Door Harness
C
Order of installation may vary. Refer to appropriate sections for instructions.
Hinge-side harness connectors:
• 4-pin male Molex connector
• 6-pin male Molex connector with ground wire
Lock-side harness connectors:
• Ring terminal
• Male RJ45 connector (crimped after cable is fed through door)
Notes:
• Connectors go on only one way. They cannot be plugged to incorrect position.
• Do not force and do not offset connectors.
• Be sure they are completely seated (flush).
PoE Hinge
4-pin F
6-pin F
PoE Lock
D
Order of installation may vary. Refer to appropriate sections for instructions.
1. Prop door open.
2. Using the ring terminal, carefully route the assembly through the door
channel to the lock.
10 1-800-810-WIRE • www.sargentlock.com • A8203A
4-pin M
4-pin F
Drain Wire
6-pin M
6-pin F
PoE Door Harness
Cable
: CAT 5e,
26 AWG stranded,
100ohm
IN220 Cylindrical Lock
IN220 PoE Lock
RJ45-M