Download Print this page

Operational Check - Sargent IN100 Installation Instructions Manual

Hide thumbs Also See for IN100:

EK Exit Device Retrofit Kit for IN100

Operational Check

IMPORTANT

In all cases, perform the following checks:

1. Ensure that inside exit bar retracts latch.

• To test cylinder, the following checks apply:

Insert key into cylinder and rotate:

a. There should be no friction against lock case, wire harness, or

b. The key should unlock the outside lever and the lever should

2. Present a valid credential* to unlock outside lever; turn lever

handle to ensure latch retracts.

NOTE: Credential should approach inscription on reader as

indicated to ensure credential is read properly. Do not wave

credential.

*Depending upon availability of access control system either a (denied) red flash or a

green and lock motor cycle (access granted).

1-800-810-WIRE • www.sargentlock.com • A8277A

: Be sure to test functions prior to closing door.

any other obstructions. If friction or binding occurs, readjust

cylinder and wiring harness to eliminate issues.

rotate freely.

Table of Contents