Table of Contents
Advertisement
Configuration and Programming
The profile is removed and the gateway is reset to factory default state.
Create a Mesh Network
To create a mesh network using the SWIFT Tools, perform the following steps.
1.
Connect the W-USB dongle device to your laptop. For more information on the USB dongle,
refer to Section 4, "USB Adapter", on page 43.
2.
Launch SWIFT Tools. Refer to Appendix A for more information.
3.
From the Home Screen, select the Create Mesh Network function.
4.
Proceed to the second step of the Create Mesh Network function by clicking the arrow
marked Next at the top of the screen.
5.
Click to select the desired gateway displayed in the Gateways in Range table and then click
Start Mesh Formation.
While the mesh is formed, SWIFT Tools helps track the number of devices that have joined the
mesh and view the progress. Mesh formation terminates 10 minutes after the last device joins the
mesh. In addition, mesh formation can be manually terminated by clicking the Start Mesh
Restructuring button.
Once mesh formation is complete, the network automatically transitions to restructure the mesh.
For further operating instructions, refer to Section 2.9, "Operations".
2.8.3 Profile Distribution
There are two ways to initiate profile distribution from the gateway.
•
Automatically after creating a profile if the profile was not created by SWIFT Tools
•
Activating the profile-creating magnetic sensor when the gateway has a profile.
After Creating a Profile
Profile distribution is automatically enabled from the gateway after creating a profile using either
magnetic sensor upon the gateway's start-up. The profile distribution automatically terminates after
10 minutes.
SWIFT™ Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000JC-E:C 5/8/2015
Figure 2.12 Reset Devices Screen
Figure 2.13 Gateways in Range Table
JFWSG FlashScan Wireless System Gateway
21
Advertisement
Table of Contents
