Table of Contents
Advertisement
Operations
2.9.5 Collapse Network Command
The collapse command is a diagnostic function to break the mesh network. All devices will retain
the profile information but will be removed from the mesh. The mesh can be reformed by activating
mesh formation.
CAUTION:
!
FIRE PROTECTION FROM WIRELESS DEVICES IS DISABLED WHEN A COLLAPSE
NETWORK COMMAND IS ISSUED.
The mesh network can be collapsed using SWIFT Tools. The mesh network can also be collapsed
at the IFC2-3030 panel or JNCA-2 when used as a primary display with the IFC2-640.
Collapse Mesh Network Using SWIFT Tools
To collapse the mesh network using the SWIFT Tools:
1.
Connect the W-USB dongle device to your computer. For more information on the USB
dongle, refer to Section 4.
2.
Launch the SWIFT Tools application. Refer to Appendix A, "SWIFT Tools" for more
information on launching the SWIFT Tools application.
3.
From the Home Screen, select the Diagnostics function.
4.
Select a Gateway from the communicator panel.
5.
Click View Mesh. The mesh is displayed.
6.
Click Advanced Functions on top of the mesh display. A drop-down list is displayed.
7.
Click Collapse Mesh. The Collapse mesh network screen is displayed.
8.
Click Yes. The network is now collapsed and a confirmation message is displayed as shown
below.
SWIFT™ Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000JC-E:C 5/8/2015
FIRE PROTECTION DISABLED
Figure 2.21 Advanced Functions Options
Figure 2.22 Collapse Mesh Network Option
Figure 2.23 Collapse Mesh Network Confirmation
JFWSG FlashScan Wireless System Gateway
27
Advertisement
Table of Contents
