Table of Contents
Advertisement
Configuration and Programming
8.
Select the device from the Communicator panel.
9.
Click Assign.
The device is now included in the list of devices with a profile assigned. When the profile is
assigned, the green LEDs turn on steady for 10 seconds.
3.5.2 Distributor Mode
Converting a Device into a Distributor
NOTE: Only a device with a profile can be used as a distributor.
To turn a device into a distributor:
1.
Power up the device with one battery installed.
2.
Ensure that the device is in the profile modification mode. If the device is in profile
modification mode, the yellow LED will blink once every 5 seconds. The profile modification
mode times out if the device has not received a command in one minute.
3.
Toggle the SLC address wheel between 0-1-0-1. To toggle the SLC address wheel, use a
common screwdriver to adjust the rotary switches on the device to:
1.
2.
3.
4.
NOTE: The green LED blinks every half second when the device is functioning as a distributor.
Converting a Distributor Back into a Device
To return a distributor device back to a network device, replace the batteries and provide a proper
SLC address. A normal device requires four batteries for proper operation. It is recommended to
use fresh batteries after the distributor mode.
3.5.3 Mesh Formation
To add a device to a mesh, refer to the topic, "Create a Mesh Network". To form a mesh network,
ensure that the gateway is powered on and contains a profile. Activate the mesh formation (refer to
Figure 2.2) magnetic sensor on the gateway.
SWIFT™ Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000JC-E:C 5/8/2015
Figure 3.4 Selecting a Device
Figure 3.5 Assigning a Profile
Set the address to 0.
Change the address to 1.
Change the address back to 0.
Change the address back to 1.
Wireless Devices
37
Advertisement
Table of Contents
