Table of Contents
Advertisement
Wireless Devices
3.2.2 Industry Canada
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions:
1.
This device may not cause interference, and
2.
This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
1.
L'appareil ne doit pas produire de brouillage, et
2.
L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
IC: 573X-WFSSD for detectors and IC: 573X-WFSMM for the monitor module
3.2.3 Federal Institute of Telecommunications
This device utilizes the Honeywell915 rev A radio module and complies with IFETEL standard(s).
IFT: RCPHOSW14-1983
3.3 Specifications
The following are the specifications for the wireless devices.
Radio Frequency
Maximum power output
Minimum signal strength level needed at the receiver for a primary path
with weak link trouble reporting enabled.
Minimum signal strength level needed at the receiver for a secondary
path or primary path with weak link trouble reporting disabled.
Maximum ambient noise level
Minimum battery life
3.4 Installing, Mounting, and Wiring Devices
For information on installing the wireless devices, refer to the documents referenced in Table 1.1.
3.5 Configuration and Programming
Device configuration starts with assigning a profile.
3.5.1 Assigning Profiles
To assign a profile, the device must be in a factory default state. A single red light flashes on the
LED confirming that the device is in the default state. To restore the device to factory default state,
refer to Section 3.5.4, "Restoring a Device to Factory Default".
There are two methods to assigning a profile.
34
SWIFT™ Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000JC-E:C 5/8/2015
Specification
Table 3.1 Wireless Device Specifications
Specifications
Data
Lower ISM Band (902-928 MHz)
+17dBm
-55dBm
Must be 18 dBm higher than the
noise floor down to -80dBm
-85dBm
2 years
Advertisement
Table of Contents
