Table of Contents
Advertisement
JFWSG FlashScan Wireless System Gateway
2.4 Magnet Sensors
2.4.1 Profile Magnetic Sensor
The profile magnetic sensor (refer to Figure 2.2) is used to create a unique profile upon start-up. It
can also be used to start profile distribution for a gateway that contains a profile. The LED next to
the profile magnet sensor turns on green for ½ a second when the sensor is activated.
2.4.2 Mesh Formation Magnetic Sensor
The mesh formation magnetic sensor (refer to Figure 2.2) toggles the gateway in and out of mesh
formation mode. The initial activation of the sensor puts the gateway in mesh formation mode (as
long as it contains a profile). A subsequent activation of the magnetic sensor toggles the gateway
out of mesh formation and into the initial mesh restructuring and normal mode. The gateway can be
placed back into mesh formation mode by activating the magnet sensor once again. The LED next
to the profile magnet sensor turns on green for ½ a second when the sensor is activated.
The Mesh formation magnetic sensor can also be used to create a profile on start-up for a gateway
that does not already contain a profile.
2.5 LED Indicators
The two LEDs on the gateway blink in the same pattern to allow the LED to be viewed from any
angle. LED patterns are explained in Appendix D.
2.6 Installing the Gateway
2.6.1 Before Installing
Choose a location for the gateway that is clean, dry, and vibration-free. The area should be readily
accessible with sufficient room to easily install and maintain the gateway. Metal obstructions
impede the radio frequency communication and should be avoided. Carefully unpack the system
and inspect for shipping damage if any. All wiring must comply with the national and local codes
for fire alarm systems.
12
SWIFT™ Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000JC-E:C 5/8/2015
LEDs
Figure 2.2 LEDs and Magnetic Sensors on the JFWSG
Mesh
Formation
Magnetic
Sensor
Profile
Magnetic
Sensor
Magnet Sensors
Advertisement
Table of Contents
