JFWSG FlashScan Wireless System Gateway
locating pin
2.7.2 Wiring
•
All wiring must be installed in compliance with the National Electrical Code and the local
codes having jurisdiction.
•
12-18 AWG is recommended.
For wiring connections:
1.
Strip about 3/8" of insulation from the end of the wire.
2.
Slide the stripped end of the wire under the appropriate terminal and tighten the screw.
NOTE: Do not loop the wire under the screw terminals.
14
SWIFT™ Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000JC-E:C 5/8/2015
locating pin
Figure 2.4 Attaching Cover to Mounting Plate
Mounting and Wiring
locating pin