Table of Contents
Advertisement
Wireless Devices
Repeater
The SWIFT Network does not require the use of a dedicated repeater as all wireless devices act as
repeaters. When the repeater function is needed in a location where no specific fire function is
required, a wireless monitor module or another device can be installed to act as a repeater.
3.5.4 Restoring a Device to Factory Default
Removing Profiles Without Using SWIFT Tools
A device can be restored to factory default state:
1.
Start with the device powered off. The process is performed during start-up.
2.
Power on the device by inserting a single battery into any slot in the device. The LEDs will
blink yellow twice every five seconds for one minute after inserting the battery.
3.
Toggle the SLC address wheel between 0-159-0. To toggle the SLC address wheel, use a
common screwdriver to adjust the rotary switches on the device to:
1.
2.
3.
NOTE: The above illustration depicts the rotary switches being set at address 35 (rotary switch
on 'TENS' set at 3 and rotary switch on 'ONES' set at 5. Ensure that the code wheel address
pattern is toggled within 1 minute of inserting the battery.
After the address wheel pattern is set, the LEDs in the device blink green five times followed by a
single or double red blink confirming that the device has been reverted back to factory default con-
dition.
Removing a Profile Using SWIFT Tools
To remove a profile in a device using SWIFT Tools:
1.
Connect the W-USB dongle device to your computer. For more information on the USB
dongle, refer to Section 4.
2.
Launch the SWIFT Tools application. Refer to Appendix A, "SWIFT Tools" for more
information on launching the SWIFT Tools application.
3.
From the Home Screen, select the Site Survey, Create Mesh Network, or Diagnostics
function.
4.
Click Extras and select Set device to factory default.
38
SWIFT™ Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000JC-E:C 5/8/2015
Set the address to 0.
Change the address to 159 (tens set to 15, ones set to 9).
Change the address back to 0.
5
4
3
Figure 3.6 Address Rotary Switches
6 7
8 9
6 7
8 9
10
5
11
4
12
3
13
2
2
1
14
1
0
15
0
ONES
TENS
Figure 3.7 Extras Menu
Configuration and Programming
Advertisement
Table of Contents
